Application and modeling of an integrated amorphous silicon tandem based device for solar water splitting

About the author

Félix Urbain studied Materials Science and Engineering at the RWTH Aachen University in Germany, where he received his BSc in 2010 and his MSc in 2012. He is currently pursuing his PhD at the Institute of Photovoltaics (IEK-5) in the Jülich Research Centre (Forschungszentrum Jülich) in Germany under the supervision Prof. Dr. Uwe Rau. His current research focuses on the development of thin film silicon multijunction solar cells for the application as photoelectrodes in photoelectrochemical cells for hydrogen production via water splitting. 

Application and modeling of an integrated amorphous silicon tandem based device for solar water splitting

Journal Reference

Solar Energy Materials and Solar Cells, Volume 140, 2015, Pages 275-280.

Félix Urbain1, Vladimir Smirnov1, Jan-Philipp Becker1, Uwe Rau1, Jürgen Ziegler2, Bernhard Kaiser2, Wolfram Jaegermann2, Friedhelm Finge1

[expand title=”Show Affiliations”]
  1. IEK-5 Photovoltaik, Forschungszentrum Jülich, D-52425 Jülich, Germany
  2. Institute of Materials Science, TU Darmstadt, D-64287 Darmstadt, Germany
[/expand]

Abstract

Direct solar-to-hydrogen conversion via water splitting was demonstrated in an integrated photovoltaic–electrochemical (PV–EC) device using a hydrogenated amorphous silicon thin film tandem junction (a-Si:H/a-Si:H) solar cell as photocathode. The solar cell was adapted to provide sufficient photovoltage to drive both the hydrogen and oxygen evolution reactions. The best results, in terms of photoelectrochemical stability and performance, were obtained with an Ag/Pt layer stack as H2 evolving photocathode back contact and with a RuO2 counter electrode for O2 evolution. Under irradiation by simulated sunlight (AM 1.5 spectrum with 100 mW/cm2), we achieved 6.8% solar-to-hydrogen efficiency at 0 V applied bias in a two-electrode set-up. This sets a fresh benchmark for integrated thin film silicon tandem based photoelectrochemical devices. In addition, the photovoltage at constant current (−3 mA/cm2) was measured over a prolonged period of time and revealed an excellent chemical stability (operation over 50 h) of the photocathode. Furthermore, we present an empirical serial circuit model of the PV–EC device, in which the corresponding photovoltaic and electrochemical components are decoupled. This allows for a detailed comparison between the solar cell and the PV–EC cell characteristics, from which the relevant loss processes in the overall system could be identified. The model was further used to compare calculated and measured photocurrent–voltage characteristics of the investigated PV–EC device which showed excellent agreement.

Go To Solar Energy Materials and Solar Cells

 

 

Check Also

Germano-Silicate Resonators for Ultralow-Loss Visible Integrated Photonics

Significance  Reference Chen HJ, Colburn K, Liu P, Yan H, Hou H, Ge J, Liu …