Effect of ECAP processing on corrosion resistance of AE21 and AE42 magnesium alloys

Applied Surface Science, Volume 281, 15 September 2013, Pages 44-48. 

P. Minárik, R. Král, M. Janeček. 

Charles University, Department of Physics of Materials, Prague, Czech Republic.

 

Abstract

Corrosion properties of AE21 and AE42 magnesium alloys were investigated in the extruded state and after subsequent 8 passes of Equal Channel Angular Pressing (ECAP) via route Bc, by Electrochemical Impedance Spectroscopy (EIS) in 0.1 M NaCl solution. The resulting microstructure was observed by the Transmission Electron Microscope (TEM) and the Scanning Electron Microscope (SEM). Corrosion layer created after 7 days of immersion was observed by (SEM) in order to explain different evolution of the corrosion resistance after ECAP processing in both alloys. It was found that Al-rich Al11RE3 dispersed particles (present in both alloys) strongly influence the corrosion process and enhance the corrosion resistance. Ultra-fine grained structure was found to reduce the corrosion resistance in AE21. On the other hand, the microstructure of AE42 after ECAP and particularly the better distribution of the alloying elements in the matrix enhance the corrosion resistance when compared to the extruded material.

Go to Journal

 

 

Check Also

Quantum Leap in QLEDs: Pioneering the Future of Optoelectronics with Smart Material Discovery - Advances in Engineering

Quantum Leap in QLEDs: Pioneering the Future of Optoelectronics with Smart Material Discovery