Identification of factors that dominate size effect in micro-machining

A.J Mian, N. Driver, P.T. Mativenga
Manufacturing and Laser Processing Group, School of Mechanical, Aerospace and Civil Engineering, The University of Manchester, M13 9PL, Manchester, United Kingdom ,Received 29 September 2010. Revised 10 January 2011. Accepted 14 January 2011. Available online 2 February 2011

 

Abstract

In micro-machining the so called “size effect” is identified as critical in defining process performance. Size effects refers to the phenomenon whereby the reduction of the undeformed chip thickness to levels below the cutting edge radius, or gain size of the workpiece material begins to influence workpiece material deformation mechanisms, chip formation and flow. However, there is no clear agreement on factors that drive this size effect phenomenon. To explore the significance of cutting variables on the size effect, micro-milling tests were conducted on Inconel 718 nickel alloy using 500 μm diameter carbide end mill. The experimental design was based on an L9 Taguchi orthogonal array. Fast Fourier transform (FFT) and wavelet transform (WT) were applied to acoustic emission (AE) signals to identify frequency/energy bands and hence size effect specific process mechanism. The dominant cutting parameters for size effect characteristics were determined by analysis of variance (ANOVA). These findings show that despite most literature focussing on chip thickness as the dominant parameter on size effect, the cutting velocity is also a dominant factor. This suggests that manipulating the cutting speed is also an effective strategy in reducing burr thickness, optimising surface finish and in breaking the lower limit of micro-machining.

Go to Journal

Check Also

Fatigue Crack Growth Behavior of WAAM Steel Plates: Experimental Analysis and Comparative Study - Advances in Engineering

Fatigue Crack Growth Behavior of WAAM Steel Plates: Experimental Analysis and Comparative Study