Advances in Engineering Advances in Engineering features breaking research judged by Advances in Engineering advisory team to be of key importance in the Engineering field. Papers are selected from over 10,000 published each week from most peer reviewed journals.
Nuclear Engineering and Design, Volume 249, August 2012, Pages 166-171
Wei Liu, Kazuyuki Takase
Research Group for Thermal and Fluid Engineering, Division of Nuclear Data and Reactor Engineering, Nuclear Science and Engineering Directorate, Japan Atomic Energy Agency (JAEA), Tokai, Ibaraki 319-1195, Japan
Abstract
A technique for the measurement of surface temperature and surface heat flux was developed. This technique involves two steps: (1) measurement of the inner block temperatures near the surface using special micro temperature sensors; and (2) solving an inverse heat conduction problem (IHCP) to obtain the surface heat flux and surface temperature by using the measured inner block temperature data as input. For the inner block temperature measurement, special T-type temperature sensors with a common positive pole were introduced. A total 10 special micro temperature sensors are placed radially at a pitch of 0.5 mm and at a depth of 3.1 um beneath the boiling surface. The developed system was used to measure the change in the surface heat flux and surfacetemperature during a boiling process. Experiments were performed for pool boiling at atmospheric pressure. The results from the experiments showed that the special T-type temperature sensors with a common positive pole can measure the temperature change during a boiling process. By using the measured inner temperatures, one-dimensional IHCP was solved to obtain the change of the surface heat flux and surface temperature with the time. The increase in the surface heat flux with the formation of big bubbles was calculated successfully.
