AC shunt calibration using a current-bridge method and its validation

IEEJ Transactions on Electrical and Electronic Engineering, Volume 9, Issue 6, pages 577–580, 2014.

Saytaro Kon * , Tatsuji Yamada.

National Metrology Institute of Japan (NMIJ), National Institute of Advanced Industrial Science and Technology (AIST), Umezono1-1-1, Tsukuba, Ibaraki, Japan.

 

Abstract

 An AC shunt calibration system using a current-bridge method is developed, and its measurement uncertainties are estimated. A comparison of the calibration results obtained using the current-bridge method with the results using DC resistance and AC–DC difference methods was performed to verify the system. These comparison results show that the current-bridge-based system performs well with small measurement uncertainties for both the AC resistance and phase angle of the AC shunts up to 1 kHz.

© 2014 Institute of Electrical Engineers of Japan. Published by John Wiley & Sons, Inc.

 

Go To Journal

 

Check Also

Light-Speed Encryption: Unlocking the Future with Spatially Incoherent Diffractive Neural Networks - Advances in Engineering

Light-Speed Encryption: Unlocking the Future with Spatially Incoherent Diffractive Neural Networks